Installing a kitchen sink sprayer 1

Installing a kitchen sink sprayer 1

Installing a kitchen sink sprayer 1 – Cold water; 2 – a supply of hot water; 3 – Connect the hose to the spray gun; 4 – mixer control lever; 5 – spray; 6 – overflow wash; 7 – siphon; 8 – dirty water drain pipe; 9 – Hose Sprayer Before installing dispensers bowl should prepare for a second hole spray. The distance of the hole from the mixer can be arbitrary. Counting is performed See More…

Posted on April 23, 2014, 12:39 am By
Categories: News
In addition, it should not allow

In addition, it should not allow

In addition, it should not allow permeation of water through the valve in a closed position; – Ensure a constant water level in the reservoir at a pressure variation in the water network, there is an increase or decrease in pressure of 0.1 MPa should not change the position of the water level in the reservoir is more than 4 mm. Fig.107. Device float valve: 1 – pressing plate; 2 – laying; See More…

Posted on April 18, 2014, 6:02 pm By
Categories: News
In a system with natural

In a system with natural

In a system with natural circulation is necessary to provide pressure, so the boiler is set below the radiator (or a special recess in the floor or in the basement or ground floor). This is explained by the fact that the greater the difference levels of the heating element and heat emitters, the higher the pressure. Fig.101. Scheme heating system with See More…

Posted on April 16, 2014, 1:10 pm By
Categories: France
And some of them water is not

And some of them water is not

And some of them water is not heated so it was necessary to mix it with cold, so goes directly into the faucet. The water temperature in this case is adjusted by changing the heating power. Fig.97. Electric heater flow types: – automatic with mixer tap; b – with storage capacity Complete with more complex models such heaters sold faucets and fittings, the water See More…

Posted on April 11, 2014, 7:12 pm By
Categories: France
Motion of a file relative to the

Motion of a file relative to the

Motion of a file relative to the workpiece surface must be horizontal. Pipes opilivaem flat file: first rough treatment make a file number 0, then adjusted with a file number 4 or number 5. If the pipe in a vise mounted horizontally, while the file resembles the swing – its position in relation to the pipe changes. If vertically, in the course of a file See More…

Posted on April 11, 2014, 6:46 pm By
Categories: France
If the apartment is equipped with

If the apartment is equipped with

If the apartment is equipped with cast iron valves, it is desirable to have a new head for emergency housing and stem assembly, as with time due to rust steel rod can grow together with cast iron head housing. Better to give preference cast iron valves with brass rods, as they are more durable. When buying a new valve should pay particular attention to the design See More…

Posted on April 10, 2014, 4:59 am By
Categories: Storage

Next Page